Setting The Default Transmission Mode (Tx Mode/Default Setting) - Kyocera KM-C2630D Operation Manual

Setting the Default Transmission Mode (TX Mode/Default setting)

You can select which transmission mode, Memory Transmission or Direct Feed Transmission, will be the default setting in this fax.
If you select "Dir. Feed Tx" here, the "Dir. Feed Tx" key will be shown in the basic fax screen.
* If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings.
1
Press the Default key. The Default Setting screen will
appear.
2
Press the "Fax default setting" key.
(inch)
(metric)
3
Press the " " cursor key until "TX Mode/Default" is
highlighted.
4
Press the "Change #" key.
Section 7 Various Settings and Registration
5
Select the desired transmission mode setting by pressing
either the "Memory TX" key or the "Dir. Feed Tx" key, as
appropriate.
(inch)
(metric)
6
Press the "Close" key. If you are finished making settings,
press the Reset key to return to the initial mode.
7-7