Making Volume Settings (Volume Setting) - Kyocera KM-C2630D Operation Manual

Making Volume Settings (Volume setting)

The volume of the alarm, the monitor and the speaker can be adjusted here, or you can make the alarm inaudible.
<Alarm Volume>
Sets the volume of the alarm that sounds in the event of an
error or when you press an incorrect key on the operation
panel.
<Monitor Volume>
Sets the volume of the internal speaker that allows you to
listen to conditions on the telephone line when the "On-hook"
key was NOT pressed.
<Speaker Volume>
Sets the volume of the internal speaker that allows you to
listen to conditions on the telephone line when the "On-hook"
key WAS pressed.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode
settings.
1
Press the Default key. The Default Setting screen will
appear.
2
Press the "Fax default" key.
(inch)
(metric)
Section 7 Various Settings and Registration
3
Press the " " cursor key until "Set Volume" ["Set the
sound volume"] is highlighted.
4
Press the "Change #" key.
5
Select the desired alarm volume from among "Large",
"Small" and "Off".
(inch)
(metric)
6
Select the desired monitor volume from among "Large",
"Medium", "Small" and "Off".
7
Select the desired speaker volume from among "Large",
"Medium", "Small" and "Off".
8
Press the "Close" key. If you are finished making settings,
press the Reset key to return to the initial mode.
7-5