Kyocera KM-C2630D Operation Manual page 153

Section 7
Turning Print Out of Each Report ON/OFF (Print Report setting)
Five different reports can be printed out for checking such points as whether a transmission or reception was accomplished correctly or not.
You can also have each of these reports printed out automatically or turn OFF automatic print out of each report.
<Activity Report>
Set this report to be printed out upon reaching a predetermined
number of communications in order to check the details of those
communications.
<Transmission Report>
Set this report to be printed out after each transmission to
check whether the transmission was accomplished correctly or
not.
* Select "Output on condition" and then, it is possible to set this
report to be printed out only under certain condition such as
a communication error, a Broadcast Transmission, and a
transmission that uses the timer.
<Reception Report>
Set this report to be printed out after each reception to check
whether the reception was accomplished correctly or not.
* Select "Output on condition" and then, it is possible to set this
report to be printed out only under certain condition such as
a communication error, a Polling Reception, an Encryption
Reception and an F-Code Based Confidential Reception.
<Delayed Communication Report>
Set this report to be printed out after each communication that
uses the timer is scheduled to check the information related to
that communication.
<Restricted Access Report>
Set this report to be printed out whenever Restricted Access is
turned ON in order to check the details, listed by department,
of all communications occurring under Restricted Access.
<NW-FAX Transmission Report>
When the optional Scanner Kit is installed on this fax machine,
you can have this report attached to an e-mail message in order
to check whether each Network FAX transmission was
accomplished correctly or not.
* Select "Output on condition" and then, it is possible to set this
report to be printed out only under certain condition such as
a communication error, a Broadcast Transmission, and a
transmission that uses the timer.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode
settings.
Various Settings and
Registration
1
Press the Default key. The Default Setting screen will
appear.
2
Press the "Fax default" key.
(inch)
(metric)
3
Press the " " cursor key until "Print Report" is
highlighted.
7-1