3Com V7111 - VCX 4 Channels Analog FXO Media Gateway User Manual page 69

Basic and Logging Parameters
Table 17
INI File Field Name
*
GUI Parameter Name
DHCPEnable
(Enable DHCP)
BootPRetries
EnableDiagnostics
WatchDogStatus
EnableLanWatchDog
3Com VCX V7111 VoIP SIP Gateways User Manual
Valid Range and Description
0 – Disable (default)
1 – Enable
After the Gateway is powered up it will try first to communicate with
BootP server; if BootP server is not responding and DHCPEnable =1
the Gateway will send DHCP request to configure its IP address and
other network parameters from enterprise DHCP server.
The DHCPEnable is special Hidden parameter. Once defined, and
saved in flash it will be used even if it does not appear next time in INI
file.
1 = Single BootP request
2 = 2 BootP retries - (3 seconds)
3 = 3 BootP retries - (default, 6 seconds)
4 = 10 BootP retries - (30 seconds)
5 = 20 BootP retries - (60 seconds)
6 = 40 BootP retries - (120 seconds)
7 = 100 BootP retries - (300 seconds)
15 = BootP retries forever. Number of BootP retries, and then DHCP
retries (if DHCPEnable = 1) at Gateway startup.
The BootPRetries is special Hidden parameter. Once defined, and
saved in flash it will be used even if it does not appear next time in INI
file.
Note that BootPRetries parameter becomes active after the VCX
V7111 is reset and INI file is loaded. To change the parameters, first
modify the INI file, and then reset the Gateway.
0 = No diagnostics (default)
1 = Perform diagnostics
0 = Disable Gateway's watchdog
1 = Enable Gateway's watchdog (default)
0 – Disable LAN Watchdog (default)
1 – Enable LAN Watchdog
VCX V7111 restarts if LAN failure is detected
69