Bootp And Tftp Procedures - 3Com V7111 - VCX 4 Channels Analog FXO Media Gateway User Manual

When working without a proxy server, the Tel to IP Routing table needs to be defined:
7
Enter in the Destination Phone Prefix (prefix of the called number) and the associated IP
address.
In the following example, an outgoing (Tel->IP) call with the prefix number of 512 is sent
to IP address 10.2.201.11; while all other numbers starting with 51 are sent to IP address
10.2.201.12. Assuming that the Gateway IP address is 10.2.1.1, all local calls starting
with 10 (such as 101-108) are routed back to the Gateway. When the proxy server is
used, the routing table can be used optionally as fallback in case of failure.
Click Submit and close the window.
8
Tel to IP routing table
Figure 21
Click Reset and click OK in the prompt; wait approximately 60 seconds and refresh the
9
web page.
10 Restore your PC's IP address and subnet mask to their original values.
11 Using the Advanced Configuration and Protocol Management screens, you can modify
all SIP and other Gateway parameters. See
detailed directions of operating under web management control.
12 Finally you can establish phone calls between phones connected to the Gateway ports
(for FXS Gateway) by dialing numbers from 101 through 108.

BootP and TFTP Procedures

If the Gateway IP address is known, you can use a web browser for Gateway configuration
and provisioning. Otherwise, you can use BootP (or DHCP) and TFTP protocols for
initialization and software download.
Each time the VCX V7111 Gateway is powered-on, it performs the standard BootP
procedure.
3Com VCX V7111 VoIP SIP Gateways User Manual
"Web Management" on page 106 for
41