Web Configuration; Using The Embedded Web Server - 3Com V7111 - VCX 4 Channels Analog FXO Media Gateway User Manual

An additional level of protection is obtained by a restriction that no more than three IP
addresses can access the Embedded Web Server concurrently. With this approach, a fourth
user is told that the server is busy, even if the correct username-password was provided.
The Embedded Web Server Username-Password
The default username-password for all Gateways is:
Username = Admin
Password = Admin
Change the Web password using the Advanced Configuration Menu > Change Password
selection and then follow the pop-up window directives. The password can be a maximum of
seven characters. The new password is active only after restarting the Gateway using the
Reset button of the Embedded Web Server. Otherwise, the old password is still active.
You can reset the Web username-password (to the default values) using an INI file
parameter called ResetWebPassword. The Web password is automatically the default
password.

Web Configuration

The Embedded Web Server can be configured using INI file parameters.
Read-only Mode
The Embedded Web Server can be initialized to read-only mode by setting the
DisableWebConfig = 1 INI file parameter (the default state is read-write mode). In this mode,
all web pages are presented in read-only mode. By selecting this mode, you disable the
capability to modify the configuration data. In addition, you do not have access to the
Change Password page or to the Reset page. When the Gateway is controlled through PCI,
the Embedded Web Server is always in read-only mode.
Disable/Enable Embedded Web Server
To deny access to the Gateway through HTTP protocol, you have the capability to disable
the Embedded Web Server task. To disable the Web task, use an INI file parameter called
DisableWebTask. The default is to Web task enabled. When the Gateway is controlled
through PCI, the Embedded Web Server is always activated.

Using the Embedded Web Server

This section explains how to use the Embedded Web Server. After the initial IP address is
set to the Gateway it is possible to connect with the integral web-based configuration
application.
3Com VCX V7111 VoIP SIP Gateways User Manual 107