Basic, Logging, And Web Parameters - 3Com V7111 - VCX 4 Channels Analog FXO Media Gateway User Manual

Users do not have to specify all parameters, as each unspecified parameter is set to its
default value. Using the INI file resets all unspecified parameters to their default values.
The Channel Parameters define the DTMF/MF, Fax and Modem transfer modes. See
"Appendix C: DTMF, Fax, and Modem
these modes.

Basic, Logging, and Web Parameters

In Table 17, where there are parameters shown in brackets they refer to the format
in the Embedded Web Server
Basic and Logging Parameters
Table 17
INI File Field Name
*
GUI Parameter Name
MGControlProtocolType
DSPVersionTemplateNumber
EthernetPhyConfiguration
DNSPriServerIP
(DNS Primary Server IP)
DNSSecServerIP
(DNS Secondary Server IP)
68
Modes" on page 153 for a detailed description of
*
.
Valid Range and Description
8 = for SIP Gateway
0 = Firmware DSP version supports PCM/ADPCM, G723 and G729
Coders (default)
1 = Firmware DSP version supports PCM/ADPCM, and NetCoder
coders
2 = Same as 0 but with voice and energy detectors
3 = Same as 1 but with voice and energy detectors
DSP templates 2 or 3 should be selected for FXO Gateway Disconnect
supervision feature, enabled by: EnableSilenceDisconnect = 1
0 = 10 Base-T half-duplex
1 = 10 Base-T full-duplex
2 = 100 Base-T half-duplex
3 = 100 Base-T full-duplex
4 = auto-negotiate (Default)
Auto-negotiate falls back to half-duplex mode (HD) when the opposite
port is not in auto-negotiate, but the speed (10 Base-T, 100 Base-T) in
this mode is always configured correctly.
IP address of primary DNS server
IP address of secondary DNS server
3Com VCX V7111 VoIP SIP Gateways User Manual