RRP 32 Mark-On-Belt (MOB) Sensor
Figure 7-34 Mark-On-Belt Sensor
Removal
1.
Remove the Waste Cartridge Assembly (RRP 23, on page 7-178).
2.
Remove the Waste Toner Agitator Motor (RRP 31, on page 7-190).
3.
Remove left-hand inner cover.
4.
Disconnect the purple harness.
5.
Remove the wiring harness from three clips.
6.
Remove the one black screw and remove the Mark-On-Belt assembly
Note
If the Mark-On-Belt adjustment procedure (RegiCon
DC685-3) is being performed, then proceed to the
following steps.
Reverse these steps to install the Mark-On-Belt assembly, or pull the MOB
sensor back into the original position if the CD685-3 procedure was
performed. Store the plunger back in the front cover.
Phaser 7700 Color Laser Printer Service Manual
7-191