RRP 12 Multi-Purpose Tray (MPT) Assembly
Figure 7-12 MPT Assembly
Removal
Note
Complete MPT removal is not necessary when doing
jobs such as shutter solenoid or main motor assembly
replacement. Remove the two MPT screws (step 5
below), and let the MPT hang by the wire harness for
partial removal.
1.
Remove the Top, Mid and Rear Covers (RRP 5, on page 7-158).
Note
Note the routing of the MPT Assembly wiring harness.
The wiring harness feeds through the access hole at the
pivot point and up to the connector. When assembling,
be sure the wire harness is behind the mounting tab.
2.
Release the wiring harness clip from the printer's frame.
3.
Pull the MPT Assembly wiring harness through the access hole.
4.
Close the Left-Hand Cover Assembly (Left Door).
5.
Remove the two screws that secure the MPT Assembly then pull the
assembly out of the printer. A slight lift on the right-hand side of the MPT
Assembly may help remove it from the printer.
Caution
The Duplex Chute (RRP 15, on page 7-170) must be in
the up position to install the MPT. Raise the Duplex
Chute by reaching into the MPT installation hole.
Caution
When reinstalling the MPT, make certain you DO NOT
pinch the wire between the left bracket and the left screw
hole.
7-166
Phaser 7700 Color Laser Printer Service Manual