Xerox 7700DX - Phaser Color Laser Printer Service Manual page 367

Removal
1. Remove the Rear Cover (RRP 72, on page 11-330).
2. Remove eight screws and loosen the two bottom screws.
3. Remove Finisher Control Board Shield.
4. Undo all the connectors.
5. Remove two screws on the left.
6. Loosen one screw on the right.
7. Undo one connector.
1. Loosen the outer screws located at the bottom of the Finisher Control
Board cover.
2. Remove the eight remaining cover screws.
3. Remove the Finisher Control Board cover.
4. Remove the four wiring connectors.
5. Remove six screws from the control board remove.
Note When reinstalling the cover, do not insert screws into the
second or fourth holes at the bottom of the cover as
these are used to secure the outer cover.
Phaser 7700 Color Laser Printer Service Manual 11-337