Figure 7-28 Print Cartridge Plate Assembly (Cont'd.) - Xerox 7700DX - Phaser Color Laser Printer Service Manual

Figure 7-28 Print Cartridge Plate Assembly (cont'd.)

4. Remove the Print Cartridge Plate Cover (RRP 24, on page 7-179).
5. Remove the Dispense Assemblies (RRP 25, on page 7-180).
6. Disconnect the wiring harnesses to all four Developer Housing Assemblies
and remove them from under their retaining clips and dress the wires so
they stick straight out the front of the printer.
7. Clear the wire harnesses from the guide located on the lower left side of
the assembly.
8. Remove the six chrome plated screws that secure the plate to the frame.
Note Stop here if only replacing developers. Complete removal
of the Print Cartridge Plate Assembly is not required for
removal of the Developer(s). Tilt the Print Cartridge Plate
Assembly forward enough to allow the Developer(s) to be
removed. Do not disconnect the Print Cartridge Plate
harnesses.
9. Remove the screw securing the Left-Hand Inner Cover and remove the
cover.
10.Disconnect the wiring harness from its retaining clip.
Phaser 7700 Color Laser Printer Service Manual
7-183