Plotter Adjustments; Z Axis (Tool Height) Adjustment - Gerber HS750 Plus User Manual

plus
64 HS750
Slide out the logic and control boards (all one piece) and place
on a static free, non-conductive surface.
4. If the boards need to be separated, locate the white tabs in
the corners of the logic board (5). Push the tabs back and
loosen the control board.
5. Gently rock the control board back and forth until it easily lifts
off the bottom board.
CAUTION: Do not overflex the board or you may damage it.

Plotter Adjustments

When making plotter adjustments, refer to the diagram on page
71 in the Appendix and the HS750
identifica-tion. Numbers in parentheses in the text refer to the
numbers in the diagram.
identified in the close-up views.

Z Axis (Tool Height) Adjustment

SYMPTOMS
The tool does not touch the material or touches only between
!
characters.
The knife does not cut deeply enough.
!
OBJECTIVE
To set the height of the lift fork for consistent contact of tool
holder with material.
ADJUSJTMENT PROCEDURE
To perform the tool height adjustment
1. Turn off power at the plotter.
2. Remove the knife and vinyl from the plotter, then return the
knife to the plotter.
3. Remove carriage cover (110) by removing screws (111).
plus
Plotter Parts List for part
and
A DETAIL B DETAIL
refer to parts