Plotter Adjustments; Cover Removal - Gerber GS750 Plus User Manual

PLOTTER ADJUSTMENTS

The section contains a troubleshooting guide to help identify
possible error conditions according to the symptoms displayed
and the recommended adjustment procedures.
It also contains a brief description of plotter adjustment problems
that should be handled by contacting Gerber Field Service
Department at 800-828-5406.
Note: Gerber warranties do not cover unauthorized repair. Some
service procedures require delicate adjustment of plotter parts. If
damage to your GS750
unauthorized service, repair will NOT be covered by any Gerber
warranty.

Cover Removal

When making certain adjustments to the GS-750, you may find it
necessary to remove the covers from the sides of the plotter.
Instructions for removal are as follows:
RIGHT COVER
1. Remove the plotter cover (with the front panel keys) by
removing the Phillips head screws which hold the cover in
place (see steps 2 and 3).
2. Remove the screw located in the center of the top edge of the
plotter right end plate.
3. Remove the screw from the center of the bottom edge of the
plotter end plate (located between the screws for the plotter
stand assembly). Reach up from inside the plotter stand to
remove this screw.
4. Pull the cover toward you. Be careful not to lift it so high that
the cable disconnects. Pivot the cover to the front of the
plotter.
plus
plotter results from improper
55