Gerber HS750 Plus User Manual page 42

plus
36 HS750
To replace and adjust the swivel knife blade
WARNING: Blades are very sharp. Take care when handling
the knife holder and blade.
CAUTION: Do not handle the blade with other tools. It is
fragile and subject to breakage if mishandled.
1. Remove the plastic adjust-
ment shoe from the base of
the tool holder by rotating it
counterclockwise until it
comes completely off the
tool holder. Leave the
rubber O ring in place.
2. With the shoe removed,
care-fully remove the old
blade by grasping it with
needle nose pliers and
pulling gently.
3. Install a new blade in the
hole provided, pushing the
blade in gently until
completely seated.
4. Carefully thread the shoe
onto the knife holder,
turning it clockwise until it is
fully seated. This will fully
expose the knife blade.
5. Rotate the shoe
counterclockwise until
approximately .005 inches
(about the thickness of two
sheets of paper) of the
knife is showing.
Rubber O ring
2. Insert and adjust
blade
1. Remove shoe
3. Thread shoe
4. Adjust for proper cut