Reset - Gerber HS750 Plus User Manual

RESET

Use the
to clear error signals, and to access Special Diagnostics.
RESET
To cause an emergency stop
Press the
sequence occurs:
1. The HS750
2. Only the current job is cleared; all other jobs in the queue
remain intact.
3. The HS750
To clear an error signal
Press the
flashing) after a power-up or plotting failure. (See the "Error
Conditions" section.)
To access diagnostics
Hold the
(See the "Special Diagnostics" section.)
key to stop plotter operation in case of emergency,
RESET
key while a job is plotting. The following
RESET
plus
operation stops immediately.
plus
returns to off-line status, as at power-up.
key to clear an error signal (rapid beeping and
RESET
key at power-up to access additional diagnostics.
RESET
Operation 45