Installation - Gerber HS750 Plus User Manual

7

INSTALLATION

As you unpack the plotter boxes, inventory the contents before
you begin to assemble the plotter. Remember to save all
packaging materials in case it becomes necessary to transport the
plotter in the future.
Follow the instructions in this section to ensure that you have
plus
properly assembled, connected, and installed the HS750 plotter
to the GRAPHIX ADVANTAGE.
All the steps below, which are discussed on pages 9-15,
MUST be followed before you have fully completed the
installation process:
1. Assembling the Plotter
2. Installing the Interior
3. Connecting the Control Module
4. Connecting the R908 Keyboard Cable
5. Installing the R907 Retaining Clip
6. Finishing the Installation
7. Connecting the Plotter
8. Power-up Sequence
plus
9. Selecting the HS750 Plotter using GSP Setup
Once these steps have been completed, you can operate the
plotter as well as add plotters, delete plotters, and assign a default
plotter to your GRAPHIX ADVANTAGE system.
plus
If you intend to operate the HS750 with software other
than the GRAPHIX ADVANTAGE, please contact your
plus
software vendor for an HS750 plotter driver and
installation instructions specific to your software.