Helpful Hints - Gerber HS750 Plus User Manual

To feed and align the material
1. Feed the material through the plotter, under all the guide bars
and over the drum.
2. Place the holes in the material over the adjustable sprockets
on the drum first (toward the rear of the plotter), making sure
to match the three closely-spaced sprocket pins and holes.
3. Place the holes in the material over the fixed sprockets at the
keypad end of the plotter, making sure to match the three
closely-spaced sprocket pins and holes
4. Center the front bail arm over the fixed sprockets and secure
into place.
5. Adjust the sliding sprockets at the rear of the plotter slightly
forward or backward to accommodate small differences in the
material width.
6. Securely close the adjustable bail arm over the adjustable
sprockets.

HELPFUL HINTS

!
!
When you change materials, open the bail arms and roll
the material back onto the roll. Tape the ends securely to
prevent the roll from unraveling.
plus
The HS750 plots so fast that heavy rolls of material
such as reflective vinyl cannot turn as rapidly as the plotter
tries to pull them. This can result in a material jam and
cause the plotter to stall. When using heavy rolls of
material such as reflective vinyl or sandblast stencil,
advance enough vinyl for an entire job before you start to
plot to eliminate the possibility of scrapping a large job in
the event of a material jam.
Materials and Tools 21