Gerber HS750 Plus User Manual page 89

KEY/FUNCTION
RUN SINGLE Key --
Plot
Controlled Stop
RUN CONT Key --
Plot
Controlled Stop
Slew Keys (Arrow
Keys)
SLOW Key
RESET Key --
Emergency Stop
Clear
Access
plus
HS750 Reference Card
Press to plot single jobs. The HS750
RUN SINGLE
status (as at power-up) after each job and waits for the operator to press
key again to plot the next job.
SINGLE
Press either Run key to pause plotting at the next logical break in the
program and check current job. Slewing while in pause will result in the
plotter returning to the position in the job and resuming the job when
is pressed again.
SINGLE
Press to plot two or more jobs continuously. The HS750
RUN CONT
one job after the other without pausing between them and remains on-line
until the key is pressed again or
RUN CONT
Press either Run key to pause plotting at the next logical break in the
program and check current job. Slewing while in pause will result in the
plotter returning to the position in the job and resuming the job when
is pressed again.
CONT
The arrow and keys do not function while a job is plotting, during an
SLOW
error condition, or while a Run light is on, even if the plotter is idle.
Press arrow keys to position carriage and material between jobs.
Up and down arrow keys move the carriage between the rear and the front
of the plotter.
Left and right arrow keys rotate the drum and feed material through the
plotter or back toward the roll holder.
Press the key (a single beep indicates slow slew mode) and press the
SLOW
arrow keys to slow slew. Press the
normal slew mode) and hold down a right or left arrow key to ramp up to high
speed slew.
Press key to stop HS750
RESET
buffer, and return the plotter to off-line status.
Press the key to stop the error signal after a power-up or plotting
RESET
failure. (See "Error Conditions" section in this manual.)
Hold the key at power-up to access additional diagnostics. (See
RESET
"Special Diagnostics" section in this manual.)
DESCRIPTION
plus
returns to the off-line
is pressed.
RESET
key again (two beeps indicate
SLOW
plus
operation, clear the current job from the
RUN
RUN
plus
plots
RUN