Run Single - Gerber HS750 Plus User Manual

plus
42 HS750

RUN SINGLE

Use
RUN SINGLE
RUN
operator to reposition material between jobs and/or to pen plot
SINGLE
using paper before cutting vinyl.
either swivel knife mode or tangential knife mode.
Plot
1. Press
mode, the light over the
knife mode, the light is off.)
2. Press
on and the HS750
received from the
plots, then a waiting list (called queue ) of these jobs is created
in the
The HS750
remains in the knife mode selected.
The HS750
again to plot the next job. If other jobs are lined up in the queue,
the green lights above the two Run keys will flash.
Controlled Stop
Use
RUN SINGLE
current job.
1. During a job, press the Run key which is currently selected
(lit). The HS750
the program.
Note: The slew keys may be pressed to maneuver the
carriage or material. However, when the Run key is pressed
again to exit the pause mode, the plotter will return the
carriage and material to the point where the job was paused.
2. Press the same Run key to resume plotting at the exact same
point.
to plot a single job. This plot mode allows the
to select a knife mode. (For swivel knife
SWIVEL KNIFE
SWIVEL KNIFE
. The light over the
RUN SINGLE
plus
plots a single job. If other plot files are
GRAPHIX ADVANTAGE
GRAPHIX ADVANTAGE
plus
returns to the off-line status after the job plots. It
plus
waits for the operator to press the
(or ) to pause plotting and check the
RUN CONT
plus
stops the plot at the next logical break in
may be used with
RUN SINGLE
key is on. For tangential
key comes
RUN SINGLE
while the first job
.
RUN SINGLE
key