Gerber HS750 Plus User Manual page 35

2. A plastic lift washer is used to reduce friction between the tool
and the lift fork of the carriage spindle during operation. There
should be one installed on the pounce wheel holder. If not, slip
a lift washer from the tool kit over the barrel and slide the
washer to the top of the holder.
3. Hold the pounce wheel holder upright over the carriage
spindle. Rotate the barrel until the desired keyway is oriented
above the protruding key inside the carriage spindle. Lower
the pounce wheel holder into the carriage spindle.
4. When the pounce wheel holder is in place, swing the tool force
arm and snap it over the cap.
5. Check the pounce wheel position by looking under the
carriage to make sure the wheel is oriented at the desired
angle.
6. Pouncing generally requires higher tool force settings than
drawing or cutting. To begin, set the tool force dial between 5
and 6. Adjust, if necessary, for paper thickness or desired hole
size. Reduce plotter speed if pouncing small holes.
POUNCE WHEEL REPLACEMENT
One pounce wheel supplied is installed in the tool holder and a
spare is included in the tool kit.
To replace the pounce wheel
1. Using the Allen wrench from the tool kit, remove the hex screw
that serves as the wheel's axle.
2. Remove the old wheel. Position the new wheel in the holder.
3. Slide hex screw through holder and wheel (as an axle) and
tighten.
Materials and Tools 29