Gerber HS750 Plus User Manual page 28

plus
22 HS750
!
!
!
Before unrolling the vinyl for a job, determine how much
material you need. Check the length of the longest line in
the job, or the width of an automatically laid out sign or
digitized design. Remember that if you are plotting in the
Axis Swap mode, you need to consider the height of the
job rather than its width.
The most practical way to unroll material for a job is to use
the slew keys on the plotter. It is best to unroll more than
enough material, rather than "just enough," in case your
estimate is not accurate. You may also pull material from
the roll by hand. This may be the simplest method if you
are plotting relatively small jobs.
When you have advanced enough material for the job,
feed it back through the plotter, or otherwise position it
appropriately according to the start position selected at the
GRAPHIX ADVANTAGE and the resulting tool starting
location. If you have a large quantity of material piling up
on the table, be sure to arrange the material in loose
accordion folds so it can feed easily. Make sure the
material is positioned to feed straight into the plotter rather
than at an angle.