Communication Parameters - Gerber HS750 Plus User Manual

plus
14 HS750
5. Carefully align all pins. Use the connector thumb screws to
secure the cable to the plotter.
Note: If a plotter is already installed in the
the
second plotter.
6. Insert the female connector of the HS750
into the socket on the rear panel of the plotter.
7. Connect the power cords for both the
system and the HS750
should be plugged into a standard, grounded electrical outlet
(115V +/- 10% AC, 60 Hz or 230V AC, 50 Hz).
8. Turn power on at the system and the plotter.

Communication Parameters

If you are connecting the HS750
GRAPHIX ADVANTAGE
communication parameters:
GRAPHIX ADVANTAGE
plus
, the plotter uses these RS-232
Communication
Parameters
9600 Baud
No Parity
8 Data Bits
1 Stop Bit
Xon/Xoff Flow Control
PLOTTER
, use the port to install a
TABLET
plus
plotter power cord
GRAPHIX ADVANTAGE
to a multiple outlet strip. The strip
plus
to a system other than the
port on