Fujitsu fi-6010N Operator's Manual page 83

5. Trace a line on the screen with your fingertip.
⇒
A corresponding line will appear on-screen.
If the line does not appear correctly, press the [Calib screen] button to return to
If the screen becomes cluttered, press the [CLR screen] button to remove all the lines.
The [Cursor on/off] button cannot be used.
6. When you are satisfied with the touch screen response, press the [Update] button.
⇒
This saves the current calibration data, completing the calibration process, and returns
you to the "Screen Calibration" screen.
ATTENTION
If the calibration is not performed carefully, or the [Enter] key is
pressed before all the calibration points have been touched, the fol-
lowing error message may appear:
Parameter Error. Please input, again.
Press the [Enter] key to dismiss the error dialog, and perform the cal-
ibration from Step 4 again, being careful to touch each calibration
point accurately.
Network Scanner fi-6010N Operator's Guide
4.5 Using the System Settings Menus
Step 4.
4
49