Connecting the Power Cable
Power
Depending on where you live, you will use either the European or US/Canadian
power cable.
• Connect the female end of the power cable to theBrick power supply.
• Connect the Brick power cable into the power port on the touchmonitor.
• Route the cable through the cable management clip.
N
:
To protect your equipment against risk of damage from electrical surges in the power
OTE
line, plug the touchmonitor's power cord into a surge protector, and then connect the
surge protector to a grounded AC electrical outlet.
Replacing the Back Cover
When all the cables have been connected:
• Replace the back stand cover.
• Power on your PC then your touchmonitor. After a brief pause the picture
should appear.
• Tilt the screen up and back to access the connection ports.
• Connect the 15-pin video cable (the ferrite bead end) to the video port on
your PC.
• Connect the other end of the video cable to the video connector on your
touchmonitor by routing the cable through the hole in the stand.
• Secure the cable to your touchmonitor and PC by turning the screws on the
connector clockwise.
• Place the cable in the cable management clip.
• Connect the other end of the USB touchscreen cable to your PC.
2-12
E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e
Connections on Underside
Power Cable
Brick Power Supply