Accessing The Vesa Mounting Interface; Mounting The Base - Elo TouchSystems Entuitive ET1725L Series User Manual

Accessing the VESA Mounting Interface

If you want to convert your desktop monitor to a wall mount or kiosk monitor,
follow the steps below to access the VESA mounting interface.
N : You will need a screwdriver for the following steps.
OTE
Remove the back cover of the stand by pulling forward on the bottom
1
cut-out.
2 Carefully lay the monitor face down. At the top of the mounting screw cover
there are two slots. With a screwdriver, pry open the mounting screw cover.
The cover fit is tight so remove it carefully.
When you remove the mounting screw cover, you will see four screws.
3
Remove the screws to mount your monitor. Refer to the drawing on page 18.
The following companies provide VESA mounting devices compatible with
your touchmonitor:
Ergotron
800-888-8458
651-681-7600
www.ergotron.com
GCX
800-228-2555
707-773-1100
www.gcx.com

Mounting the Base

You can also mount your touchmonitor by using the keyholes in the base of the
stand. These keyholes provide easy slide on mounting. You can also bolt your
touchmonitor to a tabletop or other flat surface. Please refer to Appendix C for
location and dimension of the mounting holes.
2-14
E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e
Innovative Office Products
800-524-2744
610-253-9554
www.innov-office-prod.com
MRI
800-688-2414
www.mediarecovery.com