Table of Contents
Advertisement
Connect the Power Cable
• Your monitor does not include a power cable. You may either purchase a
• Your touchmonitor has no power switch. Power on your monitor using the
• After a brief pause the picture should appear. If necessary, adjust the front
• Insert the Elo TouchTools CD-ROM in your computer's CD-ROM drive to
N
:
If this monitor is intended to be used in an existing system, the driver software may
OTE
already be installed by the system manufacturer. Skip to Chapter 3.
2-6
E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e
country specific power cable from Elo (www.elogaming.com), or construct
your own custom power cable (see Appendix B for details). Connect the
power cable to the AC connector on your touchmonitor. To protect your
equipment against risk of damage from electrical surges in the power line,
plug the touchmonitor's power cord into a switched surge protector, and then
connect the surge protector to a grounded (three-pronged) AC electrical
outlet.
power switch of the surge protector, and check that the power LED is on. If
not, refer to Chapter 4, Troubleshooting.
panel controls according to your personal preference (see Chapter 3).
install the appropriate touchscreen driver software. Follow the directions
starting on the next page to install the driver software.
Connections on underside
Power cable
Power cable
Advertisement
Table of Contents
