Elo TouchSystems Entuitive ET1725L Series User Manual page 110

This section lists the properties that are used in the MagTek Drivers. Properties can be
interrogated by issuing a
Commands for complete description and examples of all commands.
The properties are set by the driver and reflect the device's capabilities. However, the
c_xxx
properties do not indicate the configuration of the device. For example, a device may be
c_xxx
capable of reading all three magnetic tracks but be configured to only read two tracks or a MICR
reader, while often configured with a magnetic stripe reader, may not have an MSR installed.
Unless otherwise noted,
present) means that the capability is not available.
In this table, the Access information indicates whether the property can be modified (Read/Write
–R/W) or merely accessed (Read Only–R).
Property Access
account_no
amount
applied_fmt
c_card_stat
c_cardwpin
c_check
c_events
c_keypress
c_keystring
c_magnetic
c_mechanics
c_pin
c_smart
c_tracks
SECTION 2. PROPERTIES
command and modified with a
get
means the capability is available,
1
R/W Cardholder account number, including check digit. It is set by the
application to be used in PIN encryption commands (IntelliPIN).
R/W Transaction amount in cents, without punctuation (IntelliPIN).
R Indicates which format template was used to parse the magnetics
data. If no template or rule is applied, this property returns a null.
R indicates that the driver supports retrieval of card sensor status
1
(e.g., PPINSERT)
R
if the device supports reading of a card and a PIN in response to
1
a single command (e.g., IntelliPIN).
R if the device can read checks (e.g., MICR devices).
1
R
indicates that the driver supports unsolicited event notification
1
(e.g., PPINSERT).
R if the device supports retrieval of a key press (e.g., IntelliPIN).
1
R if the device supports retrieval of a sequence of key presses (e.g.,
1
IntelliPIN).
R if the device can read magnetic cards.
1
R This value indicates how the card reader's mechanism operates:
– manually operated device or no card reader
0
– device is mechanized and supports "eject"
1
– device is mechanized and supports "eject" and "confiscate"
2
R
if the device supports reading of PINs (e.g., IntelliPIN).
1
R
if the device supports smart cards.
1
R A three-character string, representing the tracks supported by the
device. The left-most position indicates track 1. Thus
indicates that the device can access tracks 1 and 2 but not track 3.
See
trk_enable
command. Refer to Section 3.
set
or null (i.e., the value is not
0
Description
to determine which tracks are enabled.
110