Ricoh InfoPrint Pro C900AFP Manual page 357

have to print the whole job or use spacing to skip a section of the job. See the
"Moving backward or forward in a job that is currently printing" on page 342
for instructions on spacing.
If you submitted this job using DPF from a host system, you can start
printing from any page in the job, but InfoPrint Manager ignores any value
you enter for the end page. You will always print to the end of the job.
Note: Spacing will only work if you send the job to a PSF DSS printer.
To restart the print job:
1. To print the entire job on the same printer it was printing on before, select the
job in the job window and click Job → Release. The job will start printing from
the first page.
2. To print the entire job on a different printer, skip to Before you Continue
between steps 8 and 9 below.
3. To print part of the job, figure out what page you want to start printing from.
Important: If you do not want to start printing from the first page of the job,
be careful when you choose which page to start with. Duplex and n-up jobs
can be confusing because you have to start printing with the first page on the
front side of the sheet of paper. If you do not choose the correct start page,
the job will print, but the sequence will probably be wrong.
For example, if you are printing a 2–up duplex job, each sheet of paper
actually has four pages printed on it, like this:
Table 50. 2–up duplex print job: front and back views
Sheet one
Sheet two
Last sheet
Front of sheet
page 1
page 3
page 5 page 7
page n-3 page n-1
Chapter 34. General Operator and User Procedures
Back of sheet
page 4 page 2
page 8
page 6
page n page n-2
339