HP Xw6200 - Workstation - 2 GB RAM Technical Reference Manual page 97

To replace an optical drive:
1 Lift the green drivelock release lever while sliding the optical drive into the bay. When the optical drive
is partially inserted, release the drivelock release lever and slide the drive completely into the bay
until the drive is secured.
CAUTION Ensure that the optical drive is secure. Failure to do so can cause damage to the drive when
moving the workstation.
2 Connect the power, drive, and audio (if required) cables to the drive and workstation.
NOTE The audio cable is only required for Linux-based systems.
If you are installing more than one optical drive, route the cable as in the following image.
NOTE The optical drive cable is routed under the system board.
Replacing Optical Drive Cable
The optical IDE cable is routed behind the system board.
1 Disconnect power from the system
workstation on its side with the system board facing up, remove all expansion boards and graphics
cards (page 90), remove the CPU heatsinks
system board, and remove the system board
2 Remove the plastic ties and tape from the IDE cable, then remove the IDE cable
3 Replace the cable and cable ties. Refer to the previous image for cable routing information.
(page 68), remove the access panel
(page 105), disconnect the optical IDE cable from the
(page 110).
REMOVAL AND REPLACEMENT OF COMPONENTS 97
(page 74), lay the