Pre-Disassembly Procedures - HP Xw6200 - Workstation - 2 GB RAM Technical Reference Manual

Pre-Disassembly Procedures

Perform the following steps before servicing the workstation:
1 Remove/disengage any security devices that prohibit opening the workstation.
2 Close any open software applications.
3 Remove any diskette or compact disc from the workstation.
4 Exit the operating system.
5 Turn off the workstation and any peripheral devices that are connected to it.
6 Remove/disengage any security devices that prohibit opening the workstation.
CAUTION Turn off the workstation before disconnecting any cables.
CAUTION The cooling fan is off only when the workstation is turned off or the power cable has been
disconnected. The cooling fan is always on when the workstation is in the "On" or "Standby" modes. You
must disconnect the power cord from the power source before opening the workstation to prevent
system board or component damage.
7 Disconnect the power cord from the electrical outlet and then from the workstation.
8 Disconnect all peripheral device cables from the workstation.
68 REMOVAL AND REPLACEMENT PROCEDURES