Using Scsiselect With Scsi Devices; Smart - HP Xw6200 - Workstation - 2 GB RAM Technical Reference Manual

Use a cable with a terminating resistor plug in the last connector.
Connect a SCSI device with its termination enabled into the last connector.
Connect an external SCSI device with its termination enabled to the external SCSI connector on the rear
panel of the workstation.
Turn on all external SCSI devices before turning on the power to the workstation. This enables the SCSI
controller to recognize the external devices.
Using SCSI Select with SCSI Devices
The Ultra160 and faster SCSI host adapters include the SCSI Select utility to configure the host adapter and to run
the SCSI disk utilities. To run the SCSI Select utility:
In POST Messages Enabled mode: Press Ctrl+A when the "Press<Ctrl><A> for SCSI Select Utility" message
appears during POST.
In POST Messages Disabled mode: When the HP logo screen appears, press any key to exit the logo screen.
Immediately after exiting the logo screen, press Ctrl+A to access the SCSI Select utility.
A menu appears with the following options:
Configure/View Host Adapter Settings
SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Additional Options
Boot Device Options
SCSI Device Configuration
Advanced Configuration Options
SCSI Disk Utilities
Lists all SCSI devices and SCSI ID numbers
NOTE For additional information about configuring POST message display status, refer to
Setup Menu" on page

SMART

The SMART IDE and SCSI hard drives for HP workstations have built-in drive failure prediction that warns the user
or the network administrator of an impending failure or crash of the hard drive. SMART drives track fault prediction
and failure indication parameters, such as re-allocated sector count, spin retry count, and calibration retry count. If
the drive determines that a failure is imminent, it generates a fault alert.
152 SCSI DEVICES
37.
"Computer