Hard Drive - HP Xw6200 - Workstation - 2 GB RAM Technical Reference Manual

Hard Drive

For more information on SATA hard drives and the SATA RAID configuration, see Appendix B, "SATA
Devices," on page
Removing a Hard Drive
1 Disconnect power from the system
2 Disconnect the cables from the back of the hard drive.
3 Push in on the green drivelock release tabs and slide the hard drive out of the chassis.
Installing a Hard Drive
This section describes how to install SCSI and SATA hard drives.
"Installing a SCSI hard drive" section on page 100
"intalling a SATA hard drive" section on page 103
INSTALLING A SCSI HARD DRIVE
For more information on SCSI hard drives, see Appendix B, "SCSI Devices," on
Before installing a SCSI hard drive on your system, you must give the hard drive a unique SCSI ID.
All SCSI controllers require a unique SCSI ID (0–15) for each SCSI device that is installed. The reserved
and available SCSI ID numbers are displayed in the following list:
0 is reserved for the primary hard drive (not reserved for the primary hard drive on Linux).
7 is reserved for the SCSI controller.
1 through 6 and 8 through 15 are available for all other SCSI devices.
When 0 is used for the primary hard drive, set the second hard drive to 1, the third to 2, and so on.
To set the SCSI ID on a drive, see the instructions on top/back of the hard drive for the correct jumper
settings. The drive probably displays a diagram of the jumper block. This diagram shows you which
blocks to cover with your jumper to get the desired ID.
100 REMOVAL AND REPLACEMENT PROCEDURES
155.
(page 68) and remove the access panel (page 74).
page 151.