Removing The Network Board - Canon LBP3310 User Manual

Removing the Network Board

Remove the network board using the following procedure. Have ready the
protective plate and screws that were removed from the expansion slot when the
network board was initially installed.
CAUTION
Be sure to turn the printer and computer OFF and disconnect all the interface
•
cables and power cord from the printer before removing the network board. If a
USB cable is connected, turn the computer off, and then remove the USB cable.
If you attempt to remove the network board when the printer is ON or when any
cables are connected to the printer, this may result in an electrical shock.
Be careful when handling the network board. Touching the edges or any sharp
•
parts of the network board may result in personal injury.
1
Turn the printer OFF.
2
If a USB cable is connected, turn the computer off, and then
disconnect the USB cable from the printer.
3
Disconnect the power plug from the AC power outlet.
4
Remove the power cord from the printer.
5
Disconnect the LAN cable from the network board.
6
Remove the two screws and remove the network board.
Store the removed network board in the original protective bag.
IMPORTANT
Do not touch the network board parts, printed circuits, or connectors with your
•
hands.
Do not drop screws, paper clips, staples, or other metal objects inside the printer. If
•
any of these objects should drop inside the printer, do not plug the power plug into
the AC power outlet and contact your local authorized Canon dealer.
Be sure not to misplace the removed screws. You will need them when you install
•
the network board again.
Network Board 9-31
9