Removing The Network Board - Canon Laser Shot LBP5000 User Manual

12
Remove the network board, then reset the DIP switch 1 to
OFF.
Set the DIP switches with the tip of a ball-point pen etc.
IMPORTANT
When setting the DIP switches, be careful not to damage the main board with the
tip of a ball-point pen etc. Do not use a sharp object such as a mechanical pencil.
13
Install the network board.
14
Connect the interface cables except for the USB cable, and
connect the power cord.
15
Plug the power plug into the AC power outlet.
16
Connect the USB cable as needed.

Removing the Network Board

Remove the network board using the following procedure. Have ready the protective
plate and screws for the expansion slot removed when the network board was installed.
CAUTION
• Be sure to turn the printer and computer OFF and disconnect all the interface
cables and power cord from the printer before removing the network board. If a
USB cable is connected, turn the computer off, and then remove the USB cable.
If you attempt to remove the network board when the printer is ON or any cable
is connected to the printer, this may result in an electrical shock.
• Be careful when handling the network board. Touching the edges or a sharp
portion of the network board may result in personal injury.
OFF
1 0 0
L N K
E R R
C 1
N B -
DIP switch 1
1 2 3 4
OFF
Network Board
6
6-33