Miscellaneous Printer Problems - Brady BBP81 User Manual

Miscellaneous Printer Problems

Table 20
recommended solutions.
Problem
The LCD displays a
language that I
cannot read
The LCD is missing
characters or parts of
characters
Changes in
parameter settings
did not take effect
5/13/08
identifies miscellaneous problems with the printer, the possible causes, and the
Table 20 • Miscellaneous Printer Problems
Possible Cause
The language parameter was
changed through the control
panel or a firmware command.
The LCD may need replacing.
Parameters are set incorrectly.
A ZPL command turned off the
ability to change the parameter.
A ZPL command changed the
parameter back to the previous
setting.
If the problem continues, there
may be a problem with the
main logic board.
BBP81 User Manual

Miscellaneous Printer Problems

Recommended Solution
1. Press SETUP/EXIT to enter configuration
mode.
2. Press MINUS (-) .
The printer displays the
parameter in the current language. Even if
you cannot recognize the characters
displayed, you can still scroll to another
language.
3. Press SELECT to select the parameter.
4. Press PLUS (+) or MINUS (-)
through the choices until you find a language
that you can read.
5. Press SETUP/EXIT .
SAVE CHANGES
The LCD displays
the original language.
6. Press SETUP/EXIT again to exit
configuration mode and save the changes
(if the language does not change, you may
need to scroll to a different save option by
pressing PLUS (+) or
previous step).
7. Repeat this process, if necessary, until you
reach the desired language.
Call a service technician.
1. Set parameters and save permanently.
2. Turn the printer off ( O
Refer to the ZPL Programming Guide, or call a
service technician.
Refer to the ZPL Programming Guide, or call a
service technician.
Call a service technician.
Troubleshooting
LANGUAGE
to scroll
in
MINUS (-) in the
) and then on ( I ).
Y882746
97