24
Printer Setup
Connect the Printer to a Power Source
Connect the Printer to a Power Source
The AC power cord must have a three-prong female connector on one end that plugs into the
mating AC power connector at the rear of the printer. If a power cable was not included with
your printer, refer to
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.
To connect the printer to a power source, complete these steps:
1.
2.
3.
4.
Y882746
Power Cord Specifications on page
Toggle the printer power switch to the off (
Plug the power cord into the AC power connector (
Plug the other end of the power cord into a power outlet near the printer.
Turn on (
I
) the printer.
The control panel LCD and lights activate, indicating that the printer is booting up.
) position.
O
BBP81 User Manual
25.
1
) on the rear of the printer.
1
5/13/08