Cleaning Schedule And Procedures; Clean The Exterior - Brady BBP81 User Manual

Cleaning Schedule and Procedures

Important •
printer.
Specific cleaning procedures are provided on the following pages.
recommended cleaning schedule. These intervals are intended as guidelines only. You may
have to clean more often, depending upon your application and media.
Area
Printhead
Platen roller
Media sensors
Ribbon sensor
Media path
Ribbon path
Tear-off bar
* Brady recommends using Preventive Maintenance Kit. In place of this kit, you may use a clean cotton swab dipped in a
solution of isopropyl alcohol (minimum 90%) and deionized water (maximum 10%).

Clean the Exterior

You may clean the exterior surfaces of the printer with a lint-free cloth and a small amount of a
mild detergent, if necessary. Do not use harsh or abrasive cleaning agents or solvents.
5/13/08
Brady is not responsible for damage caused by the use of cleaning fluids on this
Table 14 • Recommended Cleaning Schedule
Method
Solvent*
Solvent*
Air blow
Air blow
Solvent*
Solvent*
Solvent*
BBP81 User Manual

Cleaning Schedule and Procedures

Table 14
.
Interval
Direct Thermal Mode: After every roll of
media (or 500 feet of fanfold media).
Thermal Transfer Mode: After every roll of
ribbon or three rolls of media.
Once a month.
Routine Maintenance 79
shows the
Y882746