Brady BBP81 User Manual page 104

98 Troubleshooting
Miscellaneous Printer Problems
Problem
The printer fails to
calibrate or detect the
top of the label.
Non-continuous
labels are being
treated as continuous
labels.
All lights are on, but
nothing displays on
the LCD, and the
printer locks up.
The printer locks up
while running the
Power-On Self Test.
Y882746
Table 20 • Miscellaneous Printer Problems (Continued)
Possible Cause
The printer was not calibrated
for the label being used.
The printer is configured for
continuous media.
The driver or software
configuration is not set
correctly.
The printer was not calibrated
for the media being used.
The printer is configured for
continuous media.
Internal electronic or firmware
failure.
Main logic board failure.
BBP81 User Manual
Recommended Solution
Perform the calibration procedure in
Media and Ribbon Sensor Sensitivity on page
Set the media type to noncontinuous media. See
Set Media Type on page 58.
Driver or software settings produce commands
that can overwrite the printer configuration.
Check the driver or software media-related
setting.
Perform the calibration procedure in
Media and Ribbon Sensor Sensitivity on page
Set the media type to noncontinuous media. See
Set Media Type on page 58.
Call a service technician.
Call a service technician.
Calibrate
55.
Calibrate
55.
5/13/08