Power Cord Specifications - Brady BBP81 User Manual

Power Cord Specifications

Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific, three-conductor grounded
plug configuration.
Depending on how your printer was ordered, a power cord may or may not be included. If one
is not included or if the one included is not suitable for your requirements, see
refer to the following guidelines:
• The overall cord length must be less than 9.8 ft. (3 m).
• The cord must be rated for at least 10 A, 250 V.
• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic
interference.
5/13/08
Figure 6 • Power Cord Specifications
1
4
1
AC power plug for your country—This should bear
the certification mark of at least one of the known
international safety organizations
2
3-conductor HAR cable or other cable approved for
your country.
3
IEC 320 connector—This should bear the
certification mark of at least one of the known
international safety organizations
4 Length ≤ 9.8 ft. (3 m). Rating 10 Amp, 250 VAC.
Figure 7 • International Safety Organization Certifications
BBP81 User Manual
Connect the Printer to a Power Source
2
3
(Figure 7).
(Figure 7).
Printer Setup 25
Figure 6 and
Y882746