Table of Contents
Advertisement
62
Configuration
Control Panel Parameters
Parameter
Y882746
Table 12 • Printer Parameters (Page 9 of 22)
Action/Explanation
Set Printhead Cleaning Interval for Early Warning
This parameter appears only when Early Warning for Maintenance is
enabled. This value should correspond to the length of the media or ribbon
roll that you are using.
Default Value: 450 M/1476 FT
Selections: 100 M/328 FT to 450 M/1476 FT in 50 M increments
To change the value shown:
1. Press
SELECT
to select the parameter.
2. Press
PLUS (+)
or
the desired number of inches of media or ribbon.
When the printhead reaches the set length,
PRINTHEAD
the printer generates an alert.
3. Press
SELECT
to accept any changes and deselect the parameter.
Reset Printhead Cleaning Counter for Early Warning
This parameter appears only when Early Warning for Maintenance is
enabled.
To reset the printhead cleaning counter:
1. Press
SELECT
to select the parameter.
2. Did you clean the printhead?
• If you cleaned the printhead, press
• If you did not clean the printhead, press
3. Press
to accept any changes and deselect the parameter.
SELECT
Set Printhead Life for Early Warning
This parameter appears only when Early Warning for Maintenance is
enabled. Set this value to the number of inches of media that the printhead
is expected to print.
Default Value: 1,000,000 inches
Range: 100 to 1,000,000 inches
To change the value shown:
1. Press
SELECT
to select the parameter.
2. Press
MINUS (-)
3. Press
to increase the value of the digit.
PLUS (+)
When the printhead reaches the set length,
HEAD
appears on the LCD. If the alert function is enabled, the
printer generates an alert.
4. Press
SELECT
to accept any changes and deselect the parameter.
BBP81 User Manual
MINUS (-)
to set the printhead cleaning interval to
appears on the LCD. If the alert function is enabled,
PLUS (+)
MINUS (-)
to move the cursor.
WARNING CLEAN
YES
to select
.
NO
to select
.
WARNING REPLACE
5/13/08
Hide quick links:
Advertisement
Table of Contents
