Brady BBP81 User Manual page 77

Parameter
ZPL and XML only
ZPL and XML only
5/13/08
Table 12 • Printer Parameters (Page 18 of 22)
Action/Explanation
Set Delimiter Character
The delimiter character is a two-digit hex value used as a parameter place
marker in ZPL/ZPL II format instructions. See the ZPL Programming
Guide for more information.
Note • Do not use the same hex value for the control, format, and
delimiter character. The printer must see different characters to
work properly.
Default Value: 2C ,
Range: 00 to FF
To change the value shown:
1. Press to select the parameter.
SELECT
2. Press
MINUS (-)
3. Press
PLUS (+)
4. Press SELECT to accept any changes and deselect the parameter.
Select ZPL Mode
The printer remains in the selected mode until it is changed by this
parameter or by using a ZPL/ZPL II command. The printer accepts label
formats written in either ZPL or ZPL II, eliminating the need to rewrite any
ZPL formats that already exist. See the ZPL Programming Guide for more
information on the differences between ZPL and ZPL II.
Default Value: ZPL II
Range: ZPL II, ZPL
To change the value shown:
1. Press to select the parameter.
SELECT
2. Press PLUS (+)
3. Press SELECT to accept any changes and deselect the parameter.
Select Backfeed Sequence
This parameter sets when label backfeed occurs after a label is removed in
some print modes. It has no effect in Rewind mode. This setting is
superseded by ~JS when received as part of a label format (see the ZPL
Programming Guide for more information).
Default Value: AFTER DEFAULT (90%)
Selections: DEFAULT, AFTER, OFF, BEFORE, 10%, 20%, 30%, 40%,
50%, 60%, 70%, 80%
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+)
3. Press SELECT to accept any changes and deselect the parameter.
BBP81 User Manual
to move to the next digit position.
to increase the value of the digit.
or MINUS (-) to toggle between the options.
or MINUS (-) to scroll through the options.
Configuration
Control Panel Parameters
Y882746
71