Brady BBP81 User Manual page 75

Parameter
ZPL and XML only
ZPL and XML only
5/13/08
Table 12 • Printer Parameters (Page 16 of 22)
Action/Explanation
Set Protocol
Protocol is a type of error checking system. Depending on the selection, an
indicator may be sent from the printer to the host computer signifying that
data has been received. Select the protocol that is requested by the host
computer. Further details on protocol can be found in the ZPL
Programming Guide.
Default Value: NONE
Selections: NONE, BRADY, ACK_NAK
BRADY
Note •
BRADY
response messages are sequenced. If
selected, the printer must use
protocol.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+)
3. Press SELECT to accept any changes and deselect the parameter.
Set Network ID
This parameter assigns a unique number to the printer when the printer is
operating in an RS422/485 multi-drop network environment (an external
RS422/485 adapter is required). This gives the host computer the means to
address a specific printer. This does not affect TCP/IP or IPX networks.
Default Value: 000
Range: 000 to 999
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (-)
3. Press PLUS (+)
4. Press to accept any changes and deselect the parameter.
SELECT
Set Communications Mode
The communication diagnostics mode is a troubleshooting tool for
checking the interconnection between the printer and the host computer.
For more information, see
Default Value: NORMAL MODE
Selections: NORMAL MODE, DIAGNOSTICS
To select communication diagnostics mode:
1. Press SELECT to select the parameter.
2. Press PLUS (+)
3. Press SELECT to accept any changes and deselect the parameter.
BBP81 User Manual
ACK_NAK
is the same as
DSR/DTR
or MINUS (-) to scroll through the options.
to move to the next digit position.
to increase the value of the digit.
Communications Diagnostics Test on page
or MINUS (-) to toggle between the options.
Configuration
Control Panel Parameters
, except that
BRADY
is
for host handshake
106.
Y882746
69