Table of Contents
Advertisement
106
Troubleshooting
Printer Diagnostics
Communications Diagnostics Test
The communication diagnostics test is a troubleshooting tool for checking the interconnection
between the printer and the host computer.
When the printer is in diagnostics mode, it prints all data received from the host computer as
straight ASCII characters with the hex values below the ASCII text. The printer prints all
characters received, including control codes such as CR (carriage return).
typical test label from this test.
Note •
To use communications diagnostics mode, complete these steps:
Y882746
The test label prints upside-down.
Figure 21 • Communications Diagnostics Test Label
1.
Set the print width equal to or less than the label width being used for the test. See
Print Width on page 59
2.
Set the printer to DIAGNOSTICS. For instructions, see
on page
69.
The printer enters diagnostics mode and prints any data received from the host computer
on a test label
3.
Check the test label for error codes. For any errors, check that your communication
parameters are correct.
Errors show on the test label as follows:
•
FE indicates a framing error.
•
OE indicates an overrun error.
•
PE indicates a parity error.
•
NE indicates noise.
Turn the printer off (
O
4.
operation.
for more information.
) and then back on (
I
) to exit this self test and return to normal
BBP81 User Manual
Figure 21
shows a
Set Communications Mode
Set
5/13/08
Hide quick links:
Advertisement
Table of Contents
