Brady BBP81 User Manual page 72

66 Configuration
Control Panel Parameters
Parameter
Y882746
Table 12 • Printer Parameters (Page 13 of 22)
Action/Explanation
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1. Press SELECT to select the parameter.
2. If prompted for a password, enter the printer password. For
instructions, see
The display shows
3. Press PLUS (+)
The display shows
4. Do you want to continue?
• Press
MINUS (-)
INITIALIZE FLASH
• Press PLUS (+)
When initialization is complete, the control panel displays
INITIALIZING MEMORY COMPLETED
Note • Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
5. Press SELECT to accept any changes and deselect the parameter.
Print Sensor Profile
A sensor profile shows sensor settings compared to actual sensor readings.
This label (which will extend across several actual labels or tags) can be
used to troubleshoot printing problems. To interpret the results of the
sensor profile, see Sensor Profile on page
To print a sensor profile:
1. Press SELECT to select the parameter.
2. Press
PLUS (+)
media sensor profile.
3. If the sensitivity of the sensors must be adjusted, perform
Media and Ribbon Sensor Sensitivity on page
4. Press SELECT to accept any changes and deselect the parameter.
BBP81 User Manual
Change Password-Protected Parameters on page
INITIALIZE FLASH?
YES
to select .
ARE YOU SURE?
NO
to select to cancel the request and return to the
prompt.
YES
to select and begin initialization.
107.
to start this standard calibration procedure and print a
50.
.
.
Calibrate
55.
5/13/08