The Channel Settings Section - MOTU Traveler-mk3 User Manual

THE CHANNEL SETTINGS SECTION

The channel settings section in the CueMix FX
window (Figure 11-1) displays three tabs for
Channel, EQ and Dynamics settings for the
channel with the current focus. There are also two
global tabs: the Meter Bridge and the Reverb
Processor, as shown below.
Tabs for the channel that
currently has the focus
Figure 11-7: The Channel Settings section.
86
Tabs for the global meter
bridge and reverb processor
The Channel tab
The Channel tab (Figure 11-8) displays settings for
input channels. Click any focus button in the
Inputs tab to view the Channel tab settings for the
channel.
Figure 11-8: The Channel tab.
Signal flow
Settings in the Channel tab occur just before the
EQ, dynamics and reverb sends in the Input tab
channel strip (Figure 11-3 on page 82). Input
channel signal flow is as follows: pad/reference
level, trim, overload protection, phase, stereo
versus M/S decoding, width, L/R swap, EQ,
dynamics and reverb send.
Pad and reference level
The Pad and Reference Level section (Figure 11-8)
lets you control the pad switch for mic inputs and
the +4/-10 dB reference level for TRS inputs. If a
mic input is currently in focus, the pad switch is
enabled and the reference level switches are grayed
C U E M I X F X