Traveler-Mk3 Setup Menu - MOTU Traveler-mk3 User Manual

TRAVELER-MK3 SETUP MENU

To access the Traveler-mk3 SETUP menu, push the
PARAM knob until you see Traveler-mk3 SETUP
displayed in the LCD. This menu provides basic
features for managing the Traveler-mk3 hardware.
Turn the PARAM knob to access each setting,
explained briefly below.
LCD Contrast
Turn the VALUE knob to adjust the LCD contrast.
Figure 6-11: In setup mode, the LCD displays a setup parameter in the
top row of the LCD and the current setting in the bottom row.
When viewing CueMix settings
in the LCD, push the CHANNEL
knob to cycle among four main
mixer menus: MIX, IN (inputs),
OUT (outputs) and REVERB.
Turn it to choose a channel.
Turn the PAGE knob to view settings for
each channel. Push it to jump to the
next section or back to the beginning.
Figure 6-10: The Traveler-mk3 front panel LCD controls.
T R A V E L E R - M K 3 F R O N T P A N E L O P E R A T I O N
Push the PARAM knob to cycle
among three global menus:
CueMix (mixer), AUDIO
(settings) and Traveler-mk3
SETUP.
Turn and/or push the
VALUE knob to adjust
the current setting.
Save/Name Preset
An Traveler-mk3 preset holds all current
CueMix FX mix settings (everything in the
CUEMIX menu). SETUP menu and AUDIO menu
parameters are not included. Turn the VALUE
knob to move from character to character in the
preset name. Turn PAGE to change the currently
flashing letter. Once you've named the preset, push
VALUE to save it, turn it again to choose the
desired preset slot you wish to save it to (1-16), and
the push again to confirm the save. To cancel the
save operation at any time by turning the PARAM
knob.
Load Preset
Turn VALUE to choose the preset you wish to load
(1-16) and push VALUE to load it.
The LCD is divided into four
sections that correspond to the
four knobs to the left.
47