Cuemix Menu - MOTU Traveler-mk3 User Manual

Type II — for 2x optical connection to MOTU
■
products that are equipped with optical ports and
support 2x operation
Turn the VALUE knob to select an optical port and
push the knob to toggle between the Type I and
Type II setting.

CUEMIX MENU

To access the CUEMIX menu, push the PARAM
knob until you see CUEMIX displayed in the LCD.
This menu displays the settings for the
Traveler-mk3 CueMix FX mixer.
CueMix mixer basics
It is much easier to navigate the CUEMIX menu in
the LCD if you have a general understanding of the
CueMix FX mixer. We strongly recommend that
you review chapter 11, "CueMix FX" (page 77)
before learning the LCD, especially "CueMix FX
basic operation" on page 79.
CUEMIX menu organization
Mixer settings are divided into four sub-menus,
which correspond to the Inputs, Mixes, Outputs
and Reverb tabs in the CueMix FX software:
IN (inputs)
■
OUT (outputs)
■
MIX (Mixes)
■
REVERB (reverb processor)
■
Navigating the four main menus
To access the four main menus above, push the
CHANNEL knob repeatedly. Then turn the
CHANNEL knob to select the desired channel or
mix.
T R A V E L E R - M K 3 F R O N T P A N E L O P E R A T I O N
The IN (inputs) menu
Push the CHANNEL button repeatedly until you
see "I:" in the channel section of the LCD
(Figure 6-12). This is similar to accessing the
Inputs tab in CueMix FX console ("The Inputs tab"
on page 82).
" I: " Indicates The current
the IN (inputs) channel.
menu.
"Pages" are groups of
channel settings, such
as one band of EQ.
Figure 6-12: The IN (inputs) menu.
Choosing a channel
Once you see the Inputs menu (Figure 6-12) in the
LCD, turn the CHANNEL knob to select the
desired input that you wish to edit. This is roughly
equivalent to specifying an input channel strip to
work with in the Inputs tab in CueMix FX software
(Figure 11-3 on page 82).
Choosing a setting to modify
Once you've selected an input channel, you can
access the various settings for that channel using
the PAGE knob and PARAMETER knobs.
Turn the PAGE knob to scroll through channel
settings such as individual bands of EQ, the
compressor, reverb sends, etc. Push the PAGE knob
to jump to the next "section" of parameters or to
jump back to the beginning of the list. This is
roughly the equivalent of moving through the
various channel controls in an individual input
Access individual parameters
here, such as the frequency
setting for a band of EQ.
Change the value of the
current parameter here.
49