MOTU Traveler-mk3 User Manual page 85

Output EQ and Dynamics
The EQ/Dynamics section in the Outputs tab
(Figure 11-6) works identically to the EQ/
Dynamics section for the Inputs tab (Figure 11-3).
See "Input EQ and dynamics" on page 83.
Output reverb send/return
The output reverb send (Figure 11-6) feeds the
signal for the output to the Traveler-mk3's global
reverb processor, where it is merged with any other
signals being fed to the reverb. The reverb's output
can then be fed back into the mixer at any output,
including the same output from which it was sent
(discussed below). The output reverb send is
disabled (grayed out) when the reverb Split Point is
set to Mixes to eliminate the possibility for
feedback loops created by reverb send/return
loops. See "Split point" on page 99.
Output name
Channel focus
EQ/Dynamics graph
EQ/Dynamics controls
EQ/Dynamics
enable/disable
Output reverb
send/return
Talkback/listenback
enable/disable
Monitor group assign
Figure 11-6: The Outputs tab.
C U E M I X F X
The output reverb return (Figure 11-6) feeds the
output of the Traveler-mk3's global reverb
processor directly to the output. This includes any
other signals currently being fed to the reverb.
Both the send and return occur after EQ and
dynamics processing, but before listenback and
talkback.
Talkback/Listenback
Click the Talkback or Listenback buttons
(Figure 11-6) to toggle whether the output pair is
included in the Talkback or Listenback group. See
"Talkback and listenback" on page 101.
Monitor group assign
Click the Monitor buttons (Figure 11-6) to toggle
whether the output pair is included in the Monitor
group. See "The Monitor Group" on page 100.
Outputs tab
EQ band selectors
LP/HP filter selector
Compressor selector
85