The Channel Settings Section - MOTU UltraLite- mk3 Hybrid User Manual

THE CHANNEL SETTINGS SECTION

The channel settings section in the CueMix FX
window (Figure 10-1) displays three tabs for
Channel, EQ and Dynamics settings for the
channel with the current focus. There are also two
global tabs: the Meter Bridge and the Reverb
Processor, as shown below.
Tabs for the channel that
currently has the focus
Figure 10-7: The Channel Settings section.
70
Tabs for the global meter
bridge and reverb processor
The Channel tab
The Channel tab (Figure 10-8) displays settings for
input channels. Click any focus button in the
Inputs tab to view the Channel tab settings for the
channel.
Figure 10-8: The Channel tab.
Signal flow
Settings in the Channel tab occur just before the
EQ, dynamics and reverb sends in the Input tab
channel strip (Figure 10-3 on page 66). Input
channel signal flow is as follows: trim, phase, stereo
versus M/S decoding, width, L/R swap, EQ,
dynamics and reverb send.
Pad and phantom
The Pad and phantom settings become active
(ungrayed) when the focus is on a mic input (or
both mic inputs). These are the same 20 dB pad
and 48V phantom power settings that you can also
control from the UltraLite-mk3 front panel TRIM
encoders. There are separate settings for each mic
input.
C U E M I X F X