The Channel Settings Section - MOTU 828 Mk III Hybrid User Manual

THE CHANNEL SETTINGS SECTION

The channel settings section in the CueMix FX
window (Figure 9-1) displays three tabs for
Channel, EQ and Dynamics settings for the
channel with the current focus. There are also two
global tabs: the Meter Bridge and the Reverb
Processor, as shown below.
Tabs for the channel that
currently has the focus
Figure 9-7: The Channel Settings section.
C U E M I X F X
Tabs for the global meter
bridge and reverb processor
The Channel tab
The Channel tab (Figure 9-8) displays settings for
input channels. Click any focus button in the
Inputs tab to view the Channel tab settings for the
channel.
Figure 9-8: The Channel tab.
Signal flow
Settings in the Channel tab occur just before the
EQ, dynamics and reverb sends in the Input tab
channel strip (Figure 9-3 on page 71). Input
channel signal flow is as follows: trim, overload
protection, phase, stereo versus M/S decoding,
width, L/R swap, EQ, dynamics and reverb send.
Pad and phantom
The Pad and phantom settings become active
(ungrayed) when the focus is on a mic input (or
both mic inputs). These are the same 20 dB pad
and 48V phantom power settings that you can also
control from the 828mk3 front panel TRIM
encoders. There are separate settings for each mic
input.
75